VTX5848 LITE 48CH 5.8G 25/100/200/400/600mW Switchable VTX Video Transmitter Module OSD Control for FPV RC Drone
Item name: VTX5848 LITE FPV video transmitter
Input voltage: DC 7-27V
Input current: 16.4V(4s), 600mW=360 MA±10MA
Output voltage: DC 5V 1A
Output power: 25/100/200/400/600mW switchable
Frequency switch: manual button/OSD (simultaneous support)
Connector: MMCX (with sma extension cable)
Mounting hole: 30.5x30.5mm, M3
Weight: ≤6.4g (without antenna and connector)
-Stable output power, long transmission distance
-Fast 5-speed power switch, independent two red indicator, indicating the current output power 25/ 200/ 400/ 600MW
-Using 4*3 LED display 48 channel
-Support OSD signal remote frequency control, support PIT mode ( omW output power only can be open in OSD)
-With power filter
-Antenna using MMCX to SMA (with 100MM extension cable), reducing the space
-Strong power chip, input up to 27V, output 5V/1A low ripple, less interference
-Do not install antenna to power up, and it will not burn the VTX
-30.5mm*30.5mm mounting hole distance, suitable for CC3D, NAZE32, F3, F4, F7 flight controller
1x VTX5848 LITE FPV video transmitter
1x 6P*1.0mm Connector cable
1x MMCX-SMA coaxial cable
What were they thinking?
Crazy placement of control buttons. On one side of the transmitter is a typical display which shows the channel, frequency and power.On the OTHER SIDE of the transmitter are two buttons: one to change the channel, the other button to change the frequency. In order to change to change transmitter power, channel or frequency you must remove the transmitter from its place to have access to both sides of the unit.Once you have it programmed to your liking it works just fine.The seller is a five star. Just the product is poorly designed.
Good Vtx if your on a budget like myself or still learning. Mmcx connector is a definite plus along with the ability to add it to a stack. Which are 2 reasons I gave this one a try...that and maybe help keep me from breaking more connectors on my previous vtxs. So far so good but I havent used it on the highest setting yet. Mounting holes weren't 30.5mm x 30.5mm So I wasn't able to add to my stack. (No room anyways on my current setup) but still makes it easier to secure in place which is nice. Overall I'm pretty happy with it.
Decent transmitter. Not 5 stars because the vtx tramp doesn't work. Resets the vtx channels and band when enabled.
Caution. It's cheap for a reason
They printed this board with incorrect spacing between mounting holes. Doesn't fit stack. Also there are two push buttons on one side for band and channel and the LED light that displays said channel is on the opposite side. Whoever signed off on this before production is likely unemployed
NOT a 30x30 mount
WARNING:. This is not a 30x30 mount. Otherwise a great vtx.
Good little vtx
Decent range and small form
Great little Vtx
Last me 1 week, no good
Was in fly didn't crash, BURNED out on me